top of page
This site was designed with the
.com
website builder. Create your website today.Start Now

RESIDENTIAL & COMMERCIAL ASPHALT PAVING

      RESIDENTIAL PAVING

 

One of the many services Celeste Sealcoating & Paving offers is residential paving. We will take care of your driveway paving needs while being mindful of your property and your neighborhood. As a leader in the paving industry, we take pride in our ability to create a beautiful new driveway for your home. As a full service paving company, we will evaluate your specific driveway needs. If your driveway is beyond a simple overlay, we will remove the old asphalt and the old base then replace it with new base material and a new asphalt surface. We are dedicated to the details of the job, from beginning to end.

      Resurfacing & Overlays

 

An overlay is when new hot top is applied over your old hot top. Low areas are shimmed flush prior to the installation of the new hot top. The thickness of the overlay may vary from 1" to as much as 2", depending on the condition of the old driveway. Overlays should not be done if the existing hot top is already flush with garage floors, patios, stairs, etc.



      Two Inch Binder Coat

 

This application is 2" of coarse binder. The binder is typically the first step in your paving process. You can leave the binder without an overlay for a short period of time but the overlay should be applied within 2-3 years after the binder has been installed. This application is recommended for homes still under renovation or new construction projects.



      Three Inch Two Coat

 

This application is two inches of binder with a one inch finish coat. It is our top of the line application. The layering of asphalt provides added strength for your driveway. This application is good for heavy traffic driveways or driveways with adverse conditions. A three inch two coat is also recommended for commercial parking lots.



      Two and a Half Inch One Coat

 

This application is very similar to the binder coat, except that it is slightly thicker and has more sand added to it so that the finish is less porous. This will allow you to let this application sit longer than just an ordinary 2" binder coat before needing to install the overlay. This is our most common residential paving application.

      COMMERCIAL PAVING

 

The first thing a customer sees when visiting your business is the parking lot. Dodging bumps and potholes is not a good first impression. Luckily, Celeste Sealcoating & Paving provides superior parking lot installation services. Commercial paving must withstand heavy amounts of traffic. As a premier New York paving company we have over 60 years of experience, and we know how to build a parking lot that will stand up to the job! We can also accommodate your sidewalk, curbing and line striping needs.

      Resurfacing & Overlays

 

If your parking lot pavement is still in relatively decent condition, we recommend an overlay. This application levels out the uneven areas and overlays the entire parking lot. The thickness for parking lots vary from a minimum of one inch to a maximum of two inches.



      Two Coat Application

 

A two coat application is a finished parking lot consisting of a layer of binder and a finish coat. Pavement thicknesses may vary based on the intended use of the parking lot. This application is recommended for commercial parking lots due to its ability to withstand high amounts of traffic.



      Two Inch Binder Coat

 

This paving application is recommended for properties that are still in the new construction phase. It is a two inch layer of coarse binder asphalt which will require a finish coat at a later date.



bottom of page